Just a quick post. I ran into an issue updating the MIM Portal.
Looking at logs, I found a line reading that a step had failed. The step
that failed was just a quick command line run of
net start fimservice. Odd step to fail on right?
After running the updater a few times I figured out the issue. The
service just was not starting within the 5 second or so time limit of
the net start command. Net start returned a
non-zero return code and the fim portal service updater treated that as
a failure.
The fix is pretty easy though. That net start command
spawns in a new cmd prompt window. When you see it, just highlight a
character inside the cmd prompt window and that will freeze the command.
Check to ensure the fimservice service is started, then press the
“enter” key while in cmd prompt to allow it to continue.
Net start will see the service is running and return zero
to the updater and the updater will happily finish up. Just keep in
mind, you have to watch out for that cmd prompt, you only have about a 5
second window to catch and pause it!
